Kukko 17-A Separating-set with quick clamping pressure spindle
This 17-A Separating Set is used for removing ball bearings, roller bearings, inner races and other tight parts if there is not enough space to use pulling hooks.
Description:
- 4-parts, the sets contain one separator, one pulling device and a pair of extensions.
- With quick-clamping pressure spindle.
- The sharp blades enable flush parts to be removed where pulling jaws cannot be used.
- The wedge-shaped separator jaws are secured underneath the component to be removed.
- The large supporting surfaces protect the parts to be pulled.
- Instructions on the cover.
- Secure storage in special foam.
- Personal KUKKO-Chip-Code.
Advantage:
- Easy to use, as the separator jaws are quickly and centrally tensioned with just one pressure spindle.
- Ultimate stability when removing, as the separator and pulling device are screwed firmly together.
- Practical package for universal use.
- Complete easy-to-manage package.
- Almost all components available as replacement parts, time-saving order process thanks to numbering system.
- Kit in the tried-and-tested KUKKO-i-Boxx-System.
Specifications:
Content:
- 17-1 Separator with quick clamping pressure spindle
- 18-1 Pulling device
- 19-1-P 2 extensions for pulling devices (pair)
Spare Parts (Sold Separately):
- 618175 Mechanical pressure spindle.
- 17-1 Separator with quick clamping pressure spindle
- 18-1 Pulling device
- 19-1-P 2 extensions for pulling devices (pair)
- 17-1-T Cross-beam
- 18-1-T Cross-beam
- 17-1-06 Spindle
- 017167 Side bolt complete
- 018265 Side bolt complete
How It Works:
- The wedge-shaped separator jaws are secured underneath the component to be removed.
- The separator jaws are prepared by tightening the nuts on the side bolts in equal measure.
- Separate the part by tightening the quick clamping pressure spindle.
- The flat surfaces of the separator blades are used to remove sensitive parts without damaging them. The separator blades provide a larger supporting surface to prevent the parts from twisting.
- For removal, the tension bolts on the pulling device have to be screwed into the separator.
- Note: The clamping depths can be increased using the extensions included in the set.
- The part is removed by tightening the spindle against the end of the shaft.
Safety Information:
- If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
- The separator blades' support surfaces must always sit fully beneath the part to be removed.
- Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
- Protective blanket required.
- Protective goggles required.
KUKKO Quality Standards:
- Quality made in Germany.
- Strong design, high performance and long service life.
- Self-healing corrosion protection KUKKoating for galvanized parts (WITHOUT chrom IV).
- Safety label to ensure protection of intellectual property.
- A tube of KUKKO special grease included for pressure spindle.
PLEASE NOTE, IMPORTANT INFORMATION:
