Allison Transmission Suite

Old Number 888005
Allison Suite - GEN IV, 1K/2K, WTEC, CEC1

The Pro-Link iQ Allison Transmission Application provides diagnostic and testing capability for the Allison 1K/2K, WTEC, and CEC1transmissions. With the combined power of the easy-to-use Pro-Link iQ and the functionality of the Allison Transmission application, service bay technicians experience unprecedented out-of-the-box productivity.

Benefits:

Easy to use
Reduces training required for set-up and/or software usage
Portable
More portable than a laptop providing the Mobile Maintenance operator with the ideal solution
No interface cable setup
No messing with cables and adapter setup
Basic Functions

Read Fault Codes
Clear Fault Codes
View Data Lists
Advanced Features

1K/2K (GEN III controllers)

Solenoid Test
Trans Fault Enable Test
Gear Commanded Test
Display I/O wire assignments and functions (enabled/disabled)
View ECU EEPROM calibration information
View shift inhibits

WTEC

Activate fast adaptive mode to allow ECU to adjust quickly to
optimum shift characteristics
Clear Active and Inactive codes
Display I/O wire assignments and functions (enabled/disabled)
Enable clutch test to perform clutch pressure test or stall test in
higher gears
Reset autodetect (WTEC III only) to verify presence of retarder,
oil level sensor, throttle, and engine coolant temperature sources
Reset throttle calibration to ensure proper TPS adjustment
Reset unadapted shifts to initial factory shift calibration settings
View ECU EEPROM calibration information
View shift inhibits
Supports WTEC II and III